SSR Roots Blower from China manufacturer
How to deal with the oil leakage of SSR Roots Blower from China manufacturer? Let's have a simple understanding together!
1. The oil of SSR Roots Blower from China manufacturer leaked into the case
Reason: The oil tank level of SSR Roots Blower from China manufacturer is too high, and it leaks from its oil outlet; its seal is damaged, causing oil leakage at the shaft end; the pressure is higher than the specified value.
Solution: Lower the oil level; replace the seal; unclog its vent.
2. The temperature of SSR Roots Blower from China manufacturer is too high
Reasons: SSR Roots Blower from China manufacturer has too much oil in the fuel tank and its filter is blocked; excessive wear of the impeller; poor ventilation, the indoor temperature is too high, resulting in high inlet temperature;
Solution: lower the oil level or carry oil; remove the blockage; lower the pressure difference through the SSR Roots Blower from China manufacturer; repair the gap; open the vent to lower the room temperature; increase the speed to prevent the belt from slipping.
3. Friction between impellers
Reason: There are impurities on the impeller, so the gap between the impellers is too small; the bearing wear causes the gap between the gaps to be large.
Solution: remove the dirt, and check the internal parts for other damage; adjust the gap between the gears.
4. Insufficient traffic of SSR Roots Blower from China manufacturer
Reason: The imported filter of SSR Roots Blower from China manufacturer is blocked;.
Solution: remove dust and blockages from the filter; tighten the belt and increase the number; adjust the inlet pressure to the specified value; check and repair the pipeline.