Magnetic Suspension Centrifugal Blower Wholesale Price tells: How to do the waterproof of centrifugal fan?


We know that the application range of centrifugal fans is very wide, so the use environment of the equipment is more complicated and may be exposed to various environments. However, the equipment itself is an electrical equipment. In order to ensure the normal operation of the use process, there are many conditions for use. Limitations, which require waterproofing, if the equipment is not waterproof, it will cause a lot of problems such as leakage and corrosion. So how to do a good job of waterproofing during use? Follow the editor of Magnetic Suspension Centrifugal Blower Wholesale Price to have a brief look!

1. A section of drainage port should be reserved at the top of the fan. The location of the drainage port is about 15 cm to 20 cm. The lower end of the wave crest opening should be properly plugged. The bottom of the wave crest must not be left out of the drain, but it needs to be tightly attached to the base.
2. There should be a flashing plate around the base of the centrifugal fan. When the flashing plate is fixed, blind rivets can be used. The diameter of the rivet is 5mm, and the density is about 10 cm. When fixing with rivets, it must be fixed firmly and not loose. The surroundings of the flashing board should be flat, and there should be no corners, let alone collapse. The surrounding flashing plate should be higher than the outer part at the side of the base, so as to prevent water accumulation in the fan in the future.
3. There should be no large areas of rust spots around the fan base.
The above is the editor of Magnetic Suspension Centrifugal Blower Wholesale Price telling: about the waterproof knowledge of centrifugal fans.

©  2022 Shandong Zhangqiu Sopladores Incorporadas S.A.  SEO Tag